Although the geometry of twist drills is more reasonable than flat drills, it still has the following disadvantages:
(1) The value of the rake angle at each point on the main cutting edge of the standard twist drill is too different inside and outside. The rake angle of the main cutting edge at the outer edge of the drill bit is approximately + 30 °; and the rake angle is approximately -30 ° near the drill core. When the rake angle is too large, the cutting edge strength is often insufficient when machining hard materials.
(2) The lateral blade is too long, and the rake angle of the lateral blade is a large negative value, ranging from -5 4 ° to -6 0 °, which will generate a large axial force.
(3) Compared with other types of cutting tools, the main cutting edge of a standard twist drill is very long, which is not conducive to chip separation and chip breaking.
(4) The secondary clearance angle of the secondary cutting edge at the land is zero, which causes increased friction between the secondary flank face and the hole wall, the cutting temperature rises, the abrasion at the corner of the outer edge of the drill bit is large, and the roughness of the processed surface deteriorates .
The above defects often make the twist drill wear fast, which seriously affects the drilling efficiency and the improvement of the processed surface quality


