-
Grinding wheel hardnessApr 28, 2020The hardness of the grinding wheel refers to the firmness of the abrasive particles and adhesive on the surface of the grinding wheel.
-
Grinding wheel safety requirementsApr 25, 20201. The diameter of the grinding wheel chuck shall not be less than one third of the diameter of the installed grinding wheel. The diameter of the grin
-
Notes on vernier calipersApr 18, 2020The vernier caliper is a relatively precise measuring tool. It should be handled lightly and must not collide or fall underground.
-
How to distinguish between grinding wheel, cutting disc and polishing disc?Oct 30, 20201. They have different functions The grinding wheel is an abrasive tool for grinding. The cutting disc is a thin slice of cut metal. The polishing she
-
Milling cutters are roughly divided intoApr 15, 20201. Flat head milling cutter, rough milling, removing a lot of blanks, fine milling of small horizontal planes or contours.
-
Milling cutter equipment maintenanceApr 13, 2020When the axis line of the milling cutter coincides with the edge line of the workpiece or is close to the edge line of the workpiece, the situation wi
-
Basic requirements of materials for cutting parts of milling cuttersApr 10, 20201) High hardness and wear resistance: At room temperature, the material of the cutting part must have sufficient hardness to cut into the workpiece; w
-
Milling cutter vibrationApr 07, 2020Because there is a slight gap between the milling cutter and the tool holder, the cutter may vibrate during processing.
-
Clamping of milling cutterApr 02, 2020The milling cutters used in machining centers mostly adopt the spring clamp set clamping method, and are in a cantilever shape when in use.
-
Milling cutter milling methodMar 31, 2020There are two ways to feed the workpiece and the direction of rotation of the milling cutter:
-
Understand milling knowledgeMar 27, 2020When optimizing the milling effect, the blade of the milling cutter is another important factor. In any milling,
-
Causes of saw blade deformation, broken teeth and cracksMar 25, 2020Problem: The cut material is skewed, the length is different, the cutting surface is uneven, there are burrs, the saw blade is deformed, the tooth is












