Knowledge

Causes of saw blade deformation, broken teeth and cracks

Mar 25, 2020 Leave a message

Problems that often occur when using saw blades

Problem: The cut material is skewed, the length is different, the cutting surface is uneven, there are burrs, the saw blade is deformed, the tooth is broken, the saw blade is broken, the life is short

Reason: (There are many conditions caused by not paying attention to details)

Material: Sometimes the problem is with the material being cut, because there are too many impurities in the purchased material, so when the saw blade encounters these foreign particles, the super-hard saw blade may break or make a loud noise, and the cut surface It will be uneven. The softer HSS blade will not break, but the cutting results will be skewed, because the blade will turn when it contacts the particles.

Saw blade: The saw blade is not properly placed under compression and deformation, the saw teeth are blunt and not worn, the deflection is poor, the number of teeth is not properly selected, the blade strength is incorrect, the wrong blade is selected, and the quality of the blade is poor.

Cutter: The state of the jig is incorrect. The number of revolutions is incorrect. The cutting speed is not correct. The cutting oil is not selected and the error factors of the blade and the cutter will affect each other.

Some customers complained that the cutting results were skewed. After we went to the site to observe the results, the feed rack was not fixed. When the factory personnel transported materials, they often accidentally collided and buckled. After the cut material feed frame is distorted, the cut material must be crooked.

Some customers complained that the circular saw blade was often broken and could not be solved. As soon as we arrived at the site, it was pointed out in the mechanical design book that when cutting longer materials, there must be a platform to prevent the cut section from shaking. However, the customer is still the same as when cutting the material, so only the saw blade is broken by the shaved material.

There are also customers who do not make horizontal corrections when installing the machine, so the machine is fundamentally crooked.

Use counterfeit machine: Because the cost of machine is mostly on mechanical materials, cheap machine means using cheap parts, of course, the quality is not guaranteed. Therefore, it may also be caused by improper collision or shaking due to insufficient mechanical stability.

Manual machine (operator): Because the manual machine is operated manually, sometimes the operator uses too much force to lower the knife or the speed of the knife is too fast, which may also cause the blade to break.

When using the saw blade, you must pay attention to the following matters

Otherwise, the above problems may still occur:

It must be ensured that the material to be cut is firmly fixed.

Set the cutting conditions according to the material being cut.

When installing the saw blade, you must clean the chips of the clamp part, and then pay attention to the direction of rotation to fix the saw blade.

Do not feed too fast when starting cutting and stopping cutting. (Possible tooth breakage and damage) Full use of cutting oil (hoping to select cutting oil in conjunction with the material being cut) Disposable circular saw blade cutters are different from ordinary circular saw blade cutters, and the correct blade must be selected.


Send Inquiry