Knowledge

Factors affecting diamond saw blades

Mar 21, 2020 Leave a message

(1) Diamond particle size: The commonly used diamond particle size is in the range of 30/35 ~ 60/80. The harder the rock, the finer the grain size should be selected. Because under the same pressure conditions, the finer and sharper the diamond is, the easier it is to cut into hard rock. In addition, generally large-diameter saw blades require high cutting efficiency, and coarser grain size should be selected, such as 30/40, 40/50; small-diameter saw blades have low cutting efficiency and require smooth rock cutting sections. Use finer particle size, such as 50/60, 60/80.


(2) Blade concentration: The so-called diamond concentration refers to the density of diamond distribution in the working layer carcass (that is, the weight of diamond contained per unit area). The “Code” stipulates that the concentration of 4.4 carats of diamonds per cubic centimeter of working carcass is 100%, and that of 3.3 carats of diamonds is 75%. The volume concentration indicates how much volume the diamond occupies in the agglomerate, and stipulates that when the volume of diamond occupies 1/4 of the total volume, the concentration is 100%. Increasing the diamond concentration is expected to extend the life of the saw blade, because increasing the concentration reduces the average cutting force per diamond. But increasing the depth will inevitably increase the cost of the saw blade, so there is a most economical concentration, and the concentration increases as the cutting rate increases.


(3) Hardness of cutter head bond: Generally speaking, the higher the hardness of the bond, the stronger its anti-wear ability. Therefore, when sawing rock with high abrasiveness, the hardness of the bond should be high; when sawing soft rock, the hardness of the bond should be low; when sawing large and hard rock, the hardness of the bond should be moderate .


(4) Force effect, temperature effect and wear and tear: During the process of cutting stone, diamond circular saw blades will be subjected to centrifugal force, sawing force, sawing heat and other alternating loads.


Send Inquiry