Knowledge

Milling cutter milling method

Mar 31, 2020 Leave a message

There are two ways to feed the workpiece and the direction of rotation of the milling cutter:

Milling

The first one is down-milling. The rotation direction of the milling cutter and the feed direction of the cutting are the same. At the beginning of the cutting, the milling cutter bites the workpiece and cuts the last chip.

The second type is reverse milling. The direction of rotation of the milling cutter and the feed direction of the cutting are opposite. The milling cutter must slide on the workpiece for a period before starting cutting, starting with the cutting thickness of zero, and the cutting thickness reaches the end of the cutting maximum.

In three-sided edge milling cutters, some end mills or face mills, the cutting force has different directions. When face milling, the cutter is just outside the workpiece, and the direction of the cutting force should be paid more attention to. During down-milling, the cutting force presses the workpiece toward the worktable, and during up-milling, the cutting force moves the workpiece away from the worktable.

As the cutting effect of down milling is the best, down milling is usually preferred. Only when the machine tool has a thread clearance problem or a problem that can not be solved by down milling, only consider reverse milling.

Under ideal conditions, the diameter of the milling cutter should be larger than the width of the workpiece, and the axis of the milling cutter should always be slightly away from the centerline of the workpiece. When the tool is placed directly against the cutting center, it is easy to produce burrs. When the cutting edge enters the cutting and exits the cutting direction of the radial cutting force will continue to change, the machine tool spindle may vibrate and be damaged, the blade may fragment and the machining surface will be very rough, the milling cutter is slightly off the center, and the cutting force direction will no longer fluctuate --The milling cutter will get a preload. We can compare center milling to driving in the center of the road.

Each time the milling cutter blade enters the cutting, the cutting edge must bear an impact load, and the magnitude of the load depends on the cross section of the chip, the workpiece material, and the type of cutting. When cutting in and out, whether the cutting edge and the workpiece can be properly engaged is an important direction.

When the axis of the milling cutter is completely outside the width of the workpiece, the impact force during cutting is borne by the outermost tip of the blade, which means that the initial impact load is borne by the most sensitive part of the tool. At the end, the milling cutter also leaves the workpiece with the tip, that is to say, the cutting force acts on the outermost tip until the impact force is unloaded from the beginning to the end of the cutting. When the center line of the milling cutter is located exactly on the edge line of the workpiece, the blade comes off the cutting when the chip thickness reaches the maximum, and the impact load reaches the maximum when cutting in and cutting out. When the axis of the milling cutter is within the width of the workpiece, the initial impact load during cutting is taken along the cutting edge by the part farther away from the most sensitive tip, and the blade withdraws more smoothly when retracting.

For each insert, the way the cutting edge leaves the workpiece is important when exiting cutting. The remaining material when approaching the retreat may reduce the blade gap somewhat. When the chip breaks away from the workpiece, an instantaneous tensile force is generated along the rake face of the blade and burrs are often generated on the workpiece. This tensile force endangers the safety of the chip edge in dangerous situations.


Send Inquiry