(1) Helix angle β The helix angle is the angle between the outermost spiral line on the helical groove of the drill bit and the axis of the drill bit after being developed into a straight line. Because the lead of each point on the spiral groove is the same, the helix angle at different diameters of the drill bit is different, the helix angle is the largest at the outer diameter, and the helix angle is smaller the closer to the center. Increasing the helix angle increases the rake angle, which is beneficial to chip removal, but the rigidity of the drill bit decreases. The helix angle of standard twist drill is 18 ° ~ 38 °. For drills with smaller diameters, the helix angle should be smaller to ensure the rigidity of the drill.
(2) Rake angle γOm [Because the rake face of the twist drill is a spiral face, the rake angle of each point on the main cutting edge is different. From the outer circle to the center, the front angle gradually decreases. The rake angle of the blade tip is about 30 °, and it is around -30 ° near the blade. The rake angle on the blade is -50 ° ~ -60 °.
(3) Back angle αOm [The back angle of the selected point on the main cutting edge of the twist drill is expressed by the feed back angle αOm in the column section at that point. The column profile is a straight line parallel to the axis of the drill bit passing through the selected point m of the main cutting edge, and the straight line rotates around the axis of the drill bit to form a cylindrical surface. αOm also changes along the main cutting edge, the closer the center is to the larger αOm. The clearance angle α of the outer circle of the twist drill is usually 8 ° ~ 10 °, and the clearance angle of the transverse edge is 20 ° ~ 25 °. In this way, it can compensate for the effect of reducing the actual working clearance angle of each point on the main cutting edge due to the axial feed movement of the drill bit, and can adapt to the change of the rake angle.
(4) The main declination angle κrm The main declination angle is the angle between the projection of the tangent to the selected point m of the main cutting edge on the base plane and the feed direction. The base surface of the twist drill is the plane containing the axis of the drill bit at the selected point of the main cutting edge. Since the main cutting edge of the drill does not pass through the axis line, the base surface of each point on the main cutting edge is different, and the main declination angle of each point is also different. When the vertex angle is grinded out, the main declination angle of each point is also determined. The main declination angle and apex angle are two different concepts.
(5) Front angle 2φ The front angle is the angle between the two main cutting edges projected on a plane parallel to it. A small sharp angle is easy to cut into the workpiece, the axial resistance is small, and the working length of the cutting edge is increased, the nominal thickness of the cutting layer is reduced, which is conducive to heat dissipation and improves the durability of the tool; if the sharp angle is too small, the strength of the drill bit is reduced, The deformation increases, the torque increases, and the drill bit breaks easily. Therefore, the reasonable angle of sharpness should be sharpened according to the strength and hardness of the workpiece material. The angle of sharpness of the standard twist drill 2φ is 118 °
(6) Bevel angle of transverse edge ψ The bevel angle of transverse edge is the angle between the main cutting edge and the transverse edge projected on a plane perpendicular to the axis of the drill bit. When the flank of the twist drill is ground, ψ naturally forms. It can be seen from Figures 3-5 that the increase in the angle ψ of the transverse blade decreases the length of the transverse blade and the axial resistance. The bevel angle of the standard twist drill is about 50 ° ~ 55 °.

