News

Effect Of Twist Drill Processing

Mar 02, 2020 Leave a message

(1) The diameter of the twist drill is limited by the hole diameter, the spiral groove makes the drill core thinner, and the bit rigidity is low; there are only two ribbed guides, the axis of the hole is easy to deflect; The drill bit is easy to swing. Therefore, the shape and position errors of the drilled holes are large.

(2) The rake face and flank face of the twist drill are curved surfaces, and the rake angle and rake angle of each point along the main cutting edge are different, and the rake angle of the transverse edge is -55 °. The cutting conditions are poor; the distribution of cutting speed along the cutting edge is unreasonable, and the cutting edge with the lowest strength has the highest cutting speed, so the wear is serious. Therefore, the precision of the processed hole is low.

(3) The full cutting edge of the main cutting edge of the drill bit participates in the cutting, and the cutting speeds of the points on the edge are not equal, it is easy to form spiral chips, and it is difficult to evacuate chips. Therefore, the chips rub against the hole wall, often scratching the hole wall, and the surface roughness after processing is very low

HSS Cobalt Taper Drill Bit

Send Inquiry